Lift Tech Marine Troubleshooting (2024)

FAQs

Why is the red light flashing on my lift tech marine? ›

This means your control panel is locked. Hold the unlock button until the lights stop flashing to unlock it. (about 10-15 seconds).

If the lift suddenly stops working, check the fuse box and replace any blown fuses. Another electrical problem that boat lift owners may encounter is a faulty wiring connection. Over time, the wiring connections can become loose or corroded, preventing the lift from functioning properly.

Press the lock/unlock button for 5 seconds to lock the control panel. Press it again for 5 seconds to unlock the control panel. When the control panel is locked the 3 lights will blink for a set amount of time and then stop. Remote controls will not work when the control panel is locked.

In many regions, local regulations require vessels carrying dangerous cargoes to exhibit a flashing red light.

An audible alarm paired with flashing lights is the most obvious indicator that your lift station requires servicing. The alarm is triggered when water levels within the sump begin to rise at an unmanageable rate because of a partial or complete system failure.

Generally speaking, the most common causes for a lift to be stuck are: Not enough oil/faulty oil level reader. Damaged pump or valve. Leak in the hydraulic system.

How Long Do Boat Lifts Last? Boat lifts are intended to last about the same length of time as your boat — or longer if you're fortunate. With proper use and regular maintenance, it's common for boat lifts to last up to 25 years.

The Boat Lift Operates in One Direction and Not In the Other

A bad drum switch, improper wiring, loose connection on one side, or corrosion can cause your lift to operate in one direction but not in the other.

Hold the lock/unlock button until the LED lights start to blink together. When the control panel is locked the lights will blink for a set amount of time and then go out. To unlock the control panel Hold the lock/ unlock button until the LED lights stop blinking together.

How do you program a tec remote? ›

A common cause of boat lift malfunctions is electrical issues. If your lift runs on electricity, power disruptions or damaged wiring can be culprits. To solve this problem, check and ensure all connections are secure and no wires are exposed or components damaged.

Sewage pumping stations are typically very quiet. The pumps are submerged below the liquid level and are virtually silent during the operation. Therefore, if your systems start to make an unusually loud noises, it's a good indication that something has gone wrong and you may need to take action.

If you try to raise or lower the engine and nothing happens, start by checking that the battery is charged and that the battery switch is in the “on” position. Next, listen for the solenoid/start relay while operating the control (tilt) switch up or down.

This is a device that monitors the battery's water level (also known as its electrolyte) and alerts the operator know when the battery needs watering. An LED light is placed on top of the battery and will blink green when electrolyte levels are okay and blink red when the battery needs watering.

A Red LED indicator will turn ON when the headphones are charging. The Red LED will turn OFF when the headphones are fully charged.

Red flashing light at the mast head is often used as an air hazard warning because of the height of the mast above the sea level.

If the Watchman display has not heard from its transmitter for more than 24 hours the number displayed will flash to indicate that it is older than 24 hours and may not now be valid.